Mazda 2 (2011-2014), Mazda 3 (2005-2013), Mazda 5 (2006-2013), Mazda 6 (2005-2013), Mazda CX-7 (2007-2012), Mazda CX-9 (2007-2015), Mazda MX-5 Miata (2006-2015), Mazda RX-8 (2005-2011)

1. Inflate all tires to pressure indicated on the tire placard.
2. Turn the ignition to ON/RUN (engine off), then to OFF.
3. Wait 15 minutes.
4. Drive a vehicle above 12mph for several minutes.
5. Sensor IDs will then register.

Mazda B Series Pickup (2007-2009), Mazda  Tribute (band) (2005-2009), Mazda Tribute (snap-in) (2009-2011)

1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to OFF position and press and release brake pedal.
3. Cycle ignition from OFF to RUN position 3 times, ending in RUN position.
4. Press and release brake pedal.
5. Turn ignition to OFF position.
6. Cycle ignition from OFF to RUN position 3 times, ending in RUN position.
7. Horn will sound once and TPMS telltale will blink once train mode is initiated. If equipped with message center, it will display TRAIN LF TIRE. Place antennae of learn tool on sidewall of LF tire near sensor to activate. Horn will sound once sensor has been recognized. Repeat step for RF, RR, and LR tires.
8. After training LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, the training procedure must be repeated.

Mazda 3 (2014-2015), Mazda 6 (2014-2015), Mazda CX-5  (2013-2015)

1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON/RUN position (engine off).
3. Apply parking brake.
4. Press and hold the TPMS set switch, located to left of the steering wheel on the knee bolster, until the TPMS symbol in the instrument cluster flashes twice and a beep is heard once. System will calibrate under normal driving conditions.

Auto Relearn Procedure (All Models; 2004-2013): 

• Confirm TPMS sensors are properly installed
• Adjust tyre pressure to placard value
• Hold the TPMS tester on the left front tyre sidewall next to the valve stem, and use the TPMS tool to activate the sensor
• Repeat for the right front, right rear and left rear sensors
• Turn the ignition ON
• Turn the ignition OFF
• Wait for 15 minutes
• Drive the vehicle for up to 10 minutes above 15 mph or until the TPMS light is off

Indirect Relearn Procedure (All Models; 2014+): 

• Adjust tyre pressure to placard value
• Apply parking brake
• Turn ignition ON
• Push and hold the SET button for at least 3 seconds
• Audible sound will alert when TPMS calibration is complete