Relearn Procedures: 

Indirect TPMS Relearn Procedure (universal – VW vehicles)

• Inflate all tyres to the pressure listed on the tyre placard
• Turn the key to the “ON” position (engine off)
• Press the TPMS reset button *, and hold until the light blinks 3 times, then release it. 
• Start the car and let it run for 20 minutes to reset the sensor.
  • * Refer to the vehicle’s owner’s manual for location of TPMS reset button (generally allocated beneath the steering wheel)

Volkswagen Jetta

Manual relearn procedure (after tyre rotation/replacement, direct TPMS, 2006-2010):

• Inflate all tires to the pressure listed on the tire placard
• Apply the parking brake and turn the ignition to ON/RUN position (engine off)
• Hold the SET (or ESP) button (located next to the gear shift) until the audio signal is heard. Audio signal confirms successful relearn.

If the above procedure fails, use the procedure below.

Manual relearn procedure (after sensor replacement, direct TPMS, 2006-2010):

• Inflate all tyres to the pressure listed on the tyre placard.
• Turn ignition to ON/RUN position (engine off).
• Enter the information center set up menu and select TIRE PRESSURE.
• Select STORE.
• SYSTEM LEARNING will appear on the display and disappear after several minutes of driving.

• Inflate all tyres to the pressure listed on the tyre placard.
• Apply the parking brake.
• The vehicle needs to stand for 20 minutes for the control module to enter learn mode.
• Drive the vehicle above 16 mph to register sensor IDs.

Indirect TPMS relearn procedure (2011-2019)

• Inflate all tyres to the pressure listed on the tyre placard.
• Turn ignition to ON/RUN position (engine off).
• Press the SET button, located in the glove box, for a minimum of two seconds.
• The TPMS Telltale will go out after an audible chime.

• Inflate all tyres to the pressure listed on the tyre placard. 
• Turn the ignition to ON/RUN position (engine off).
• Press the VEHICLE button to access the tyre pressure control menu.
• Press the RDK key to enable tyre pressure control.
• If equipped with a sensor in a spare wheel, select SPARE WHEEL MONITORING
• Press the NEW TARGET PRESSURES key. The current pressures can now be saved.

• Inflate all tyres to the pressure listed on the tyre placard.
• Turn the ignition to ON/RUN position (engine off). 
• Press the MENU button located on the Instrument Cluster.
• Use the thumbnail knob to select TIRE PRESSURE.
• Press the thumbnail knob to select. 
• Use the thumbnail knob to select STORE.
• Press the thumbnail knob to select.

Beetle (2007-2011), EOS (2007-2015), GLI (2008-2009), Golf (2010-2011), GTI (2006-2011), Jetta (2005-2011), Jetta Sportwagen (2013-2014) Passat (2006-2011), R32 (2008-2011), Rabbit (2006-2010)

Relearn Following Tire Rotation/Replacement 

• Inflate all tires to pressure listed on the tyre placard.
• Apply the parking brake and turn ignition to the ON/RUN position (engine off).
• Hold the SET (or ESP) button (located next to gear shift) until audio signal is heard. Audio signal confirms successful relearn. 

• Inflate all tires to the pressure listed on tyre placard.
• Apply parking brake.
• Vehicle needs to stand for 20 minutes in order for control module to enter learn mode. 
• Drive vehicle above 16mph to register sensor IDs.

• Inflate all tires to pressure listed on tire placard.
• Drive vehicle above 16mph to register sensor IDs.

• Inflate all tyres to the pressure listed on tyre placard.
• Turn ignition to ON/RUN position (engine off).
• Press the SET button, located in the glove box, for a minimum of two seconds. 
• The TPMS Telltale will go out after an audible chime.

• Inflate all tyres to the pressure listed on tyre placard.
• Turn ignition to ON/RUN position (engine off). 
• Navigate through the vehicle menu, by using the controls on the steering wheel, until tyre information is found. 4. Select the relearn option and follow the on-screen prompts.